Z80-MBC2与uTerm机箱前后面板

Z80-MBC2 & uTerm Enclosure Front & Back Panels

2024-01-06 23:38:11

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Front and back panels for a Z80-MBC2 & uTerm computer that makes use of a modified standard plastic enclosure.
The front panel is split down the center with an outer and an inner section to facilitate printing. Both halves are glued together before installation.
The standard enclosure is available online from several sources. (See screenshot for dimensions).
The enclosure was modified by removing the posts which secure the top and bottom halves together. Side brackets and M3 button head screws were used to fasten the two halves together. The supplied feet were also not used making use of adhesive backed rubber feet instead.
You'll also note that the power jack is labelled as 5VDC and not 9VDC as I elected not to install the 7805 regulator and power the system directly from a 5 volt wall wart.
Change the printer filament from gray to black for the lettering.