AD584 另一个带Li电池的可充电装置盒子

AD584 Another box with Li-rechargable

2024-01-07 20:29:42

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Here is a box for anther form factor voltage reference AD584, that you can buy on Aliexpress. It is quite nice tool.

I added slot for Li-Ion battery (I used Cellevia 3.7V/800mAh p/n LP453350)
I added function for missing power switch. Here I use switch TSM102, or you can use any with 6mm hole and which is not so depth.
Between battery tray and between AD584 board, there is little orifice for battery cable (left right corner).
On the bottom is square hole for molex connectow which you can additionaly solder.

Please excuse I did small mistake in design. The mount holes for AD584 not 100% fit to M3 holes in bottom part. You can use only two M3, or rather use 4x M2.5 that fits. Use large M2.5 washers from bottom and ...then fixed well :-).

Print Settings

Printer brand:
FlashForge
Printer:
Adventurer4
Rafts:
No
Supports:
No
Resolution:
0.16mm
Infill:
25%
Filament brand:
PM Filament
Filament color:
Dark grey
Filament material:
PLA
Notes:
The cover is printed in 15minutes on Adventurer 5M Pro, I use infill 50%.
On bottom part it is about 30-40minutes, I use infill below 20%.