索尼三星 KV-20FV10 前门锁机制维修 3D模型

Sony trinitron KV-20FV10 front door locking mechanism repair

2024-01-08 00:21:19

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

If like me, you have this particular model of CRT with a front door that doesn't close, this small print will help you repair that.

Print Settings

Printer brand:
Anycubic
Printer:
Kobra
Rafts:
No
Supports:
No
Resolution:
0.06
Notes:
I recommend printing this model with the smallest layer height (I used 0.06mm) for optimal results.

Post-Printing

Installation

Depending on where your locking mechanism broke on the original door, you might need to snip off the end of it for the print to sit properly.

Then, glue the piece as shown in the image below. Removing the door by gently pulling on it will greatly help with this step.

I voluntarily made the pin a the end of the part longer than needed. This is because it is a very small part and and different printers won't print it reliably. So, after gluing the piece, close the door and if it is too hard to reopen for your liking, sand of a small part of the pin and repeat the process until the door closes properly