DSLR可调节桌面支架

DSLR Adjustable Desktop Stand

2024-01-11 13:13:30

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is an adjustable and rotatable desktop stand I made for my Canon M50 so I could use it as a webcam, it should work with any compact to mid size DSLR camera.

I took inspiration from blackbearstudio's design here https://www.thingiverse.com/thing:5395698

It can be rotated a full 360 degrees and angle up approx 30 degrees and down approx 75 degrees

Printing Instructions:

All items were printed on either my Ender 3 v1 or my Ender 3 S1 Plus

If using 280mm arms for rear then use 240mm arms for front,

If using 240mm arms for rear then use 190mm arms for front

For rear arms print 2 of each so 2 standard and 2 captive nuts of your chosen length

For front arms print 1 standard and 1 captive nuts of your chosen length

I printed all main parts at 0.28mm layer height with 50% infill, they could be printed with smaller layer height for a more asthetic look but printing will take some time.

Supports only required for Base Stand

For Top and Bottom Slip Rings I printed these at 0.12mm layer height with 100% infill as I wanted these to be strong and last as they will start to wear down if the stand is rotated a lot.
I also used a little bit of silicone grease on these to help with rotation.

I also use the Ulanzi Falcam F38 quick release mounting system but there are various quick release systems available on thingiverse to print if required

Hardware Requirements:

7 x M5 x 20mm Bolts
8 x M5 Nuts (Nyloc would be best)
1 x M12 x 45mm Bolt for Base Plate
1 x M12 Nut (Nyloc Best)
1 x Gopro Thumb Screw (This could be substituted for another M5 Bolt but the gropro thumb screw makes angle adjustment simple)

Additional Resources:

Gopro Thumb Screw - https://www.thingiverse.com/thing:2394225

Tripod Screw - https://www.thingiverse.com/thing:4003381

Print the above at 0.12 layer height and 100% infill for best results.

I would really like to hear from anyone that prints this and know how you get on with it, I'm also open to suggestions for improvement of the design as I'm still relatively new to designing my own stuff.