CR-30 X 轴基座板 + 直接驱动支架

CR-30 X Axis Base Plate + Direct Drive Mount

2024-01-12 23:03:28

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Those parts are made to improve your design. I was modifiing my printer for the linear rail and didn't want to make hole at the wrong place so i copy the base plate to make my assembly and test the fit. I also wanted to know how high would become the nozzle from the conveyor.

The only thing different from the original crality plate is the round section that support the heat break. I made them a little bite wider (outside diameter) to make sure it sit well.

And as i was doing that, I did design an direct drive mount to fit on the base plate, that align the output hole of the extruder motor in the extruder. It use the same extruder, and just have to move it on top of your print head.

The motor mount is not tested yet so please share comments to improve it. I'm looking for an extention cord to plug the extruder without snipping and soldering the wire so i can go back to bowden setup.