克瑞艾蒂 Ender 3 V3 SE 发条传感器发条模块安装

Creality Ender 3 V3 SE filament runout sensor mount on extruder

2024-01-14 03:34:44

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I made this mount for the original Creality filament runout sensor, it sits directly over the extruder to minimalize waste material.

In theory, if the printer runs out of filament, the printer will auto stop the current print and resume printing only after you refill the printer and confirm to resume print

!!! sadly with the current firmware 1.0.6 it isn`t possible to use the filament sensor at all. The connector on the motherboard is a 4 pin but i modified the 3 pin on the included cable to fit on the 3 left pins on female connection at the motherboard.

The KE version of this printer has the sensor pluged in at the same connector!

If you connect the sensor and put in some filament to load the light turns blue but the printer says [filament about to run out (continue) (stop)]

Pressing continue doesn´t do anything and pressing stop cancels the current task.

Ive tried to change the pins red and yellow on the sensor cable an it doesnt change a thing.!!!

Mounting Hardware needed:

3x M3 threaded inserts
3x M3x14 original counter sunk screws (4x includet in the sensor kit)
(https://www.amazon.de/Creality-Filament-Sensor-3D-Druckerteile-Detection/dp/B0951X2VBS)

2x M3 x 16 socket head screws to replace the original cable management holder

Print Settings

Printer brand:
Creality
Printer:
Ender-3 V3 SE
Rafts:
No
Supports:
Doesn't Matter
Resolution:
0.2
Infill:
100
Filament brand:
Extrudr
Filament color:
black
Filament material:
ASA

Post-Printing

How to mount the holder and sensor:

first print the .stl file
after printing you have to set the 3x M3 threaded inserts
remove the stock cable holder for the ribbon cable
mount the printed part with the 2x M3x16 socket head screws
screw on the filament sensor with the M3x14 screws which come with the sensor
connect the cable to the sensor
secure the pin with a zip tie
i haven`t designed a cable management clip for the gantry yet i will add it later
remove the small plastic cap behind the right Z-Tower (push trough with screw driver or pen)
remove the bottom plate of the printer
push the cable through the hole an guide it towards the motherboard
cut off the right guide pin on the pin header of the sensor cable
insert the cable into the motherboard 4 pin to connect the 3 pins from the left as seen on the last picture (like on the ender 3 V3 KE)