Kyosho Ultima JJ Edition 后部支架

Kyosho Ultima JJ Edition Rear Body Mount

2024-01-15 02:22:31

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Rear body mount for the Kyosho Ultima JJ rerelease.

The Tomahawk body that is included with the Ultima JJ rerelease (if trimmed according to Kyosho's recommendations) does not fit the chassis very well. In particular the large shelf that is created by the chassis at the mid-front of the car is quite ugly in my opinion. I was surprised that I missed this detail as it was there in the press material (albeit only if you looked closely). This detail was pretty disappointing as the poor fit on the original JJ car was pretty understated in comparison. I am sure some will disagree with me, but it looks poor. I tried to bend the body outwards to cover the shelf but that came after a poor attempt at heating and reshaping. I'm sure it is possible to pre-bend ahead, but I should have thought about that before my hack job. There are lots of different options for the RC10, but most of those do not dip low enough around the shock tower to be adequately supported. This led me to develop this mount which also allows me to put on other options.

This body mount attaches to the rear "classic" wing mount holes and shifts the rear body clip hole upwards allowing for compatibility with a very wide array of classic bodies (Jammin Jumper, RC10, etc.) other than Kyosho Ultima/Ultima II/Tomahawk bodies. This additional clearance also allows for better wire management over the rear tower rather than around it. The slots allow for use zip ties/straps.