导线袋湿度计干燥管

Filament Bag Hygrometer Dryer Tube

2024-01-15 04:46:36

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Shawnkampy's desiccant tube design to which I've added a round hygrometer holder. The intent is to provide a spool-like insert for ziploc/vacuum bags for filament storage.

The tubes are removable from the hygrometer, and all parts snap/screw together. I've had best results printing at a 0.3 layer height which is both speedy, and allows the screw cap to hold onto the bottom plate.

The 2-inch tube model here is 2 parts:
Shawnkampy's original tube model
Hygrometer plate

They are grouped together in the 3mf file, but if they don't appear that way for you, center both models. Alternatively you can substitute in any of Shawnkampy's other tube lengths to adjust it for your needs.

Roughly 15g of silica gel fits in the 2 inch version, which by my read should be good for 10-15 bag openings.

The tube is removeable from the hygrometer which allows for "recharging"/discharging the silica gel in my filament dryer as I'm using filament. Around 12 hours gets it to about 80% discharge and 24 hours gets it to maximum discharge when drying at 100F with an ambient relative 10% humidity inside the dryer.

Hygrometer used:
https://www.amazon.com/gp/product/B0BHWS2L8P
This measures 45mm round according to the product page (can't remember the caliper measurement I took).

Models built in Fusion 360. The ring has a snap edge on both sides for the hygrometer/tube to attach (both sides are the same).

Print Settings

Printer brand:
Sovol
Printer:
SV07
Rafts:
No
Supports:
No
Resolution:
0.3
Notes:
Printing at 0.3 makes the bottom plate hold on the cap better.

Printed using Sovol SV-06 (not available on Thingiverse droped :-/ )