3dsjs

硅胶容器

Silica Gel Container

2024-04-30 15:41:29

使用说明

  1. 所有模型资源均由用户上传分享,内容来源于网络公开资源
  2. 侵权投诉:通过抖音私信 @jobsfan 联系我们(需附版权证明),24小时内处理
  3. 模型将通过邮件发送(5分钟内自动发送),感谢理解带宽压力,超过1小时没收到,请联系我们
关于费用

我们是爱好者共建社区,为维持服务器成本,每个模型收取微量费用(仅覆盖基础开支)。我们承诺最低成本运营,感谢您的支持!

扫码手机访问
抖音私信 @jobsfan

Summary

Silica Gel container with a screw top lid. I made this so I can recycle Silica Gel from the small bags that come with tech gear. I take the gel out of the small bags so I know by the colour change that it needs "recharged" by putting into a small oven for a few hours.

Do not use these containers in the oven, my design is very thin and will warp at low temperatures. Quicker drying by spreading the gel out on a tray.

This container will sit in the filament reel inside your dry bag to pro-long the life of your filament. I am using the eSun vacuum bags.

Print Settings

  • Printer brand:

    Anycubic

  • Printer:

    Kobra 2

  • Rafts:
    No
  • Supports:
    No
  • Resolution:
    .2
  • Infill:
    15%
  • Filament brand:

    eSun

  • Filament material:

    PLA+

  • Notes:

    Your milage may vary with your filament\printer with the bridges in this model. Older filament did not produce a great result. In my printng the 100% sized model was great and the top screwed on fine although was a bit too big for my filament reel.

    90%, fits in the reel, but the thread took a bit of back and forth to screw on securly.

Tags

硅胶容器
朋友,你觉得上面这个模型,属于下面的哪个分类?
必须全中文,且长度不超过15