完全多余的、过度复杂的洗碗机卡片发射器

T.U.O.D.T.D - Totally Unnessecary Overengineered Dishwasher Tab Dispenser

2024-01-16 06:26:35

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

T.U.O.D.T.D

Totally Unnecessarily Over engineered Dishwasher Tab Dispenser

Dispense your dishwasher tabs with power and purpose!
Only usable with tabs with water-soluble foil.

Print and use the loader!!!

The loader is slightly narrower than the main feeder, this is needed to fold in the uneven edges of the foil.
Always load your T.U.O.D.T.D with the loader!

Hardware needed

2x M3 Heat insert
1x M3x6 Screw, preferably countersunk
1x M3x20 Screw, preferably countersunk
1 or more rubber bands, i use 2x ø30mm

Post-Printing

Assemble main body

After printing and cleaning up your print, taking extra care of the mating surfaces of upper_body and lower_body.

Glue the marked surfaces of the upper_body to the lower_body.

Assemble the rest of the dispenser

Insert the heat-inserts into the upper_body and slider.
Tie the rubber band around the arm.
Use the m3x20 screw with a cap and spacer, to mount the arm to the slider.
Use the m3x6 screw and a cap to mount the arm to the upper_body.

Assemble the Loader

Add some glue to the outer edge of the loader and glue it into the adapter.
The loader tube does NOT sit flat with the bottom of the adapter, and stops about halfway in, this is correct.

The opening of the tube should be opposite of the cutout in the adapter.