智能玩家座位

Play Seat Trophy Riser Feet

2024-01-18 17:29:23

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I have a Playseat Trophy for my Sim Racing Rig. To get my monitor to swing over from my desk at a good height I had to raise the rig and I came up with this.

The front ones sit where the chair hits the ground. Watch out for correct orientation, the angle of the tubing at that point isn't symmetric. They are modeled with this.

I used these with Bed Risers I got from home depot to raise it about 7" Total.

https://www.homedepot.com/p/Everbilt-6-in-Black-Bed-Risers-4-Pack-4902244EV/306757968

The base is 2.6" x 2.6"

The small hole slot was added to attach a hose clamp, it was not needed, they snapped on perfectly.

x2 of Rear
x1 of Left Front
x1 of Right Front

I have also attached the Fusion 360 File and Step File for the design. Hopefully that will help someone else with there design.

You could try to extended the pieces I have here to your required height, but I'm not sure if it would hold the weight. The bed risers were rated for 300lbs each.