线路绳持有器与导向器 Ender 3 V3 / V2 SE KE

Spool Filament Holder & Guide Ender 3 V3 / V2 SE KE

2024-02-04 17:35:14

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

The spool is rotated 90º with weight distributed evenly.
The spool now sits above the gantry and directly in the middle which helps distribute its centre of gravity and allows the filament to roll directly down towards the extruder rather than around from one side of the spool ring.
This is coupled with a pin that is easy and quick to take in and out and fits on to a 608ZZ bearing on either side for easy rolling. This results in more consistent printing and no strain on filament feeder motor.

I have noticed less turning of multi coloured filaments as the filament comes straight down so I now have more even multi coloured prints.

I have also added a version without the filament guide if not needed.

Easy to print standing upright
Uses existing screws
No support required
30% or more infill is recommended (I printed with 40% as it didn't add much material)
4 or more walls are recommended

Print Settings

Printer brand:
Creality
Printer:
Ender-3 V3 SE
Rafts:
No
Supports:
Yes
Resolution:
0.12
Infill:
40%
Notes:
- 4 walls recommended
- use 2 x 608zz bearings for pin
- Needs support just under the cavity in the base plate