Olimpia PS 63型号碎纸机接触鼻部3D模型

Olimpia PS 63 Paper shredder contact nose

2024-03-14 06:45:09

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I tryed to make it easier for me, even putting a single sheet of paper in my paper shredder - so i filed it a bit down... the end was, it was a bit to much, so i had to reconstruct that part. It works fine, but need a little bit sanding (in the inside hole as even on the side with the contact switch) - but: it worked as a spare part really good (but not for that, what i hoped to get - you already need more than one sheet that it worked properly, but that is even originally so).

Print Settings

Printer:
Artillery Genius
Rafts:
No
Supports:
No
Infill:
20%
Filament brand:
Eryone
Filament material:
PLA
Notes:
Normally it should print well - i use a skirt for it, 'cause it's a small piece - without issues, just requires a bit sanding after the print (one of the long sides in that inner square, and the round side on the opposite direction where the small step is).