另一个隧道，再次出现...

Another funnel, again...

2024-03-17 00:04:12

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

My Vevor compressor came without hydraulic oil so I needed a funnel to fill it with oil. The funnels I had did not fit or fitted poorly. The funnel must have a spout with an offset wrt the center. The ones I found on Thingiverse did not have a spout that will fit and go inside the fill opening. Thus I create one that allows an offset spout that will fit into the fill opening. And which allows to customize all dimensions.

All parameters:

$fn the number of fragments to create a round shape like a cylinder or circle.
wallThickness the thickness of the walls, in mm.
topDiameter the diameter of the top section, in mm.
middleDiameter the diameter of the middle section, in mm.
bottomDiameter the diameter of the bottom section, in mm.
topHeight the height of the top section, in mm.
middleHeight the height of the middle section, in mm.
bottomHeight the height of the bottom section, in mm.
spoutHeight the height of the spout, in mm.
middleOffset the horizontal offset of the middle section wrt the center of the top section, in mm.
bottomOffset the horizontal offset of the bottom section wrt the center of the top section, in mm. The spout uses this offset also.
addHandle if you want a 'handle' then set this parameter to true, otherwise set it false.
handlePosition the position of the handle around the top section, in degrees. This makes it more easy to keep the 'offset' funnel in the middle position with one hand while using the other hand to poor something in the funnel.
handleHeight the height of the handle, in mm.
handleWidth the width of the handle, in mm.
addReinforcement if you want some reinforcement ribs then set it to true.