HVAC驱动齿轮

HVAC Actuator Main Gear for 2010 Chrysler Sebring

2024-03-17 09:18:21

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Replacement Main Gear for a 2010 Chrysler Sebring HVAC actuator that was making a clicking noise when the fan was turned on.

The Actuator part # is AA-113800-2640

There is a diverter inside the blower body, (if you take the cabin air filter out you can see the moving air diverter ) that is connected to an actuator and it was making a clicking noise.

After looking online, I noticed that you can remove this actuator and open it up via clips to show the Gears inside.

This part is the black main gear and it was missing a tooth causing the clicking noise.

Not sure if my printer was a bit off or my measurements but I had to sand the splined end a little bit as it was a bit tight. ( no big deal )

Fit nice after the sanding and works great.

You can find others on amazon.ca for 50 dollars or go to the wreckers for 25 plus entry fee and your time or just print this one and sand it down a bit.

Print Settings

Printer brand:
Kingroon
Printer:
Kingroon KP3S
Rafts:
Yes
Supports:
Yes
Resolution:
.04
Infill:
100%
Filament brand:
Overture
Filament color:
Blue
Filament material:
PETG
Notes:
NOTE: Don't forget to make not of the orientation of the spline with relation to the markings on the outside of the actuator casing. The spline has a space / void area that should line up with the markings. Not sure how to explain but take a look at the case where the spline is exposed through the casing, there are 3 lines / marks that should line up with the space on the gear spline.