Spin滴水托盘更换

Spinn Drip Tray Replacement

2024-03-18 00:47:24

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is an effort to improve Spinn by allowing to use taller cups and reducing some of the common maintenance steps.
I know that you can remove the drip tray to allow for larger cups, but then the cleaning process doesn't happen like it should.

Usage:

Because of the round areas, it needs supports (it should be fairly minimal).
The assembly should be pretty straight forward.

Push the bracket and funnel out of the way, then pull it back when done brewing.
For the drip tray, pull the lever for about 10 seconds to reset it when it says it's full, then push it back.
Or pull it all the way out to remove the tray.

The funnel will direct the water of the cleaning process that comes out of the coffee spout into the drip tray.
The drip tray will direct the water to wherever you want to.

Note: The end side of the hose must be lower than the drip tray (you might need to raise the machine).

Spinn-Drip-Tray

Parts:

Tray
Puller
Puller-Attachment

Need:

1x Magnet (15mm X 3mm) (actual: 15mm D, 2.6mm H), to keep the tray in place
2x Magnets (2mm X 1mm) (actual: 2mm D, 1mm H), to keep the puller lever in place
Super glue to keep the magnets in place
UV Resin or something similar to seal the tray and prevent leaks
3/16" Airline Tubing for Aquariums (actual: 5.5mm OD, 3.6mm ID), the lenght would depend on the distance to your sink or wherever you want to relocate the discharge

Optional: