键盘维修台/夹具

Keyboard repair stand / jig

2024-03-18 07:24:55

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Repairing my keyboard was annoying because the pressed keys would pop out the plastic pieces. This stand/jig screws into the keyboard top allowing the keys to hang free so you can easily reassembly the keyboard without the plastic "springs" popping out.

When re-attaching the (up facing) keyboard bottom, I attached the center screws. My small screwdriver was able to extend through the bottom and loosen the screw holding the stand/jig in. I was then able to remove it from the keyboard and attach the screw through the bottom. I then attached that side's screws and repeated it on the other side.
(This sounds more complicated than it was!)

I printed with 4 perimeters both to speed up the print and make it stronger. I used 0.3mm draft mode layers with a 0.2mm nozzle. Vertical quality really doesn't matter.

You need to print two of course.