AtomRC剑鱼三代鼻部支架

AtomRC Swordfish O3 Nose Mount

2024-03-19 12:10:49

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I modified Gizfpv's excellent nose mount to work with the DJI O3. It works well. There are a few considerations:

1 - Screw holes
2 - Mounting the O3
3 - Top vent
4 - Ballast
5 - Antenna
6 - Hardware
7 - Supports
8 - Instructions

For #1 (screw holes), the diameter of the mounting holes for the screws was too small initially. I drilled mine out and updated the design - it should work better, but I haven't tested it (don't want to reprint and waste). If they're too small, just use a 1/8" drill bit.

2 - Mounting the O3. I chose not to hard mount the air unit (the camera itself is hard mounted). I didn't have the right sized screws to hard mount the O3 and it doesn't matter much anyway. I added little side bars to hold it in place in the design. To reduce vertical movement, I just stuck some padded tape to the top of unit and left on the backing, so it could slide in and out. It's fairly well mechanically secured.

3 - Top vent. The air needs somewhere to go. I also designed a replacement for the top panel that you can print that allows air to vent out the back. I'll upload it to my profile. Also my cat chewed on the default EPP part so I needed a new one.

4 - Ballast. This makes the plane slightly nose-heavy. I had to add about 20g of weight on the back of the plane.

5 - To mount the antenna, just pick a side, force the antenna mount into the slot, and glue it in place. You can use a zip tie to secure the antenna to the mount.

6 - I used metal M3 hardware.

7 -All of these parts are designed to print without supports.

8 - See the original design (Gizfpv's) for instructions.

I butchered the Fusion360 file from Gizfpv, but I've included it here in case you want it.

AtomRC剑鱼三代鼻部支架

朋友，你觉得上面这个模型，属于下面的哪个分类？