1英寸金属导线固定支撑结构

bushing for 1" metal conduit

2024-03-23 11:09:11

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I needed bushings for 1" metal conduit ends to be able to run CAT6 without shaving the insulation off while pulling the cable and couldn't get anything in stock in town so I made this.

Printed conduit inserted end up with no rafts or supports. inside end is beveled to make it easier to push pull sticks or fish tape through from the other end of the conduit. outside face opening also angled too.

With the conduit ends filed after cutting I was able to insert these up to the little bumps on the sides and then get them all the way in with with a single tap of a small mallet for a pretty good friction fit.

Conduit I made these to use with was part number 898304 from Allied Moulded.

Print Settings

Printer brand:
XYZprinting
Printer:
da Vinci Super
Rafts:
No
Supports:
No
Resolution:
.01 mm
Infill:
10%
Filament brand:
Overture
Filament color:
Black
Filament material:
PLA
Notes:
Slicing function in XYZprinting's XYZprint 3 was used.

When I printed five at one time it took about an hour and twenty minutes to do.