微型灌溉接头

Micro Irrigation Manifold

2023-03-26 18:52:07

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

多孔管道适用于微型植物灌溉系统。它使用标准的花园水管适配器（Gardena/hozelock）连接在花园水管上。

I have included a 4 port fused manifold. All ports are active all the time the water is turned on. This model requires a lot of support. I've only included it in case there are those that don't want to build the unit.

I have split all the others and you can print which one you want and join it to the main body with a 24mmx3mm O ring in the sealing channels. You could also print a sealing gasket in TPU (attached). If you find it leaks between the layers, try reducing the layer height to .16mm or .12mm and/or increasing the hot end temperature a bit to improve layer adhesion.

It is designed to bolt together using 2.5mm hex bolts. You can either use nuts, or as I do, use 2.5mm heat inserts. The inserts go in the main unit and the bolts in the line out section of the manifold.

If you print these separate units (the output flanges) in the orientation shown, you will not require supports at all. The main hose attachment will have to be turned 180 deg to not need support. I have only presented it in this orientation so that you can see the O ring channel. The output flanges have a similar channel on the underside.

If you really want to be sure it will withstand mains pressure, print with 100% infill

Its is designed to utilise the Micro Irrigation systems that have the adjustable sprinklers that use 4mm black plastic pipe.

I found these systems fine if you piggyback about 4 of them. Anything more than that and the pressure loss is so great it renders all of them useless.

微型灌溉接头

朋友，你觉得上面这个模型，属于下面的哪个分类？