HobbyWing Max6 G1 40mm 风扇罩 (GEN 1) Spektrum 160 Dynamite Fuze 160

HobbyWing Max6 G1 40mm Fan Shroud (GEN 1) Spektrum 160 Dynamite Fuze 160

2024-03-25 02:16:42

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

抖音私信 @jobsfan

This is a pretty much all new design remixed from SirBeck58's G2 Shroud design (Thank you!)

Things I have changed in the design for the 40mm Hobbywing Max6 G1 Shroud/Cover.

Shrunk the holes for the 40mm fan down to 2.7mm so you don't have to use brass inserts (screw the fan directly to the cover). <--BE CAREFUL NOT TO USE SCREWS THAT ARE TOO LONG OVER THE CAPACITORS! If you screw is too long it WILL RUIN the caps on the ESC.
Cut out a section on the front near the motor plugs for the Max6 G1 Heatsink (designed differently than the Max6 G2)
Added strength to the motor plug face on the front and rear. (that is a weak area)
Changed up the back end that protects the capacitors to allow the wires to exit out the top of the cover.
Rounded edges all over the model to prevent wire edge wear.
Adjusted the sides to fit the Max6 G1 Heatsink.
Thickened up the rear of the cover and added a couple hold tabs and support columns.
Switched around the Fan connection and LED holes.

Enjoy! If I am not mistaken this is the first free design for the Max6 G1 variant of the ESC and much needed to simply add a better 40mm fan.