磁铁电线收纳盒

Magnetic Cable Organizer

2024-03-25 21:10:30

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I was constantly picking up cables from the floor next to my desk. I tried one of those spiral-type cable holders, but they didn't work for me (not taking a jab at them... just didn't work in my situation). So I made this.

This is a cable holder that uses magnets to hold cables in place. An angled piece is printed with "fingers" like a comb. This part is what gets mounted to the desk. It has magnets embedded in the bottom of it. Once the cables are in place, a top plate with identical "fingers" comes from the other side to cover the slots of the angled piece. A set of magnets in the top plate attract to the magnets in the bottom angled piece. This holds the cables in place.

My design criteria:
-three slots for a 4mm cable
-two slots for a 5.5mm cable
-I used the Harbor Freight rare earth magnets (come in a tube with, like, 10 of them). The hole accepts up to 2mm thick, 9mm diameter magnets.
-I set up the combs such that the magnets cannot be physically touching each other. I wasn't sure how strong the superglue was and didn't want the magnets constantly coming out. The 3mm printed space between the two magnets is strong enough to hold, but easy enough to pull apart.
-I am using a 3M hook and loop tape to hold it to the desk.

A tip, I pulled out all four magnets and laid them on a table with the same pole facing upward. I put a black dot with a Sharpie on it so I didn't lose track of the side. I would hate to get the magnets glued into the holes upside down.