Ulanzi TC001 倾斜式桌子支撑架

Ulanzi TC001 tilted desk stand

2024-03-26 06:04:24

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

For better readability of the Ulanzi TC001 clock, I have made this simple, articulated stand.
It requires two M3 brass nuts to be melted into the housing and a two M3x6mm flat head screw.
I also tried fixations which can be glued onto the housing, but the adhesive tape never held it long enough. Maybe I'll update this alternate design as well.

Print Settings

Printer brand:
Creality
Printer:
K1
Rafts:
No
Supports:
No
Resolution:
0.12
Infill:
10%

Post-Printing

After printing, I drilled 2 holes into the sides of the clock using a 4.5mm drill.
The hole on each side is approx. 16mm away from the front and back of the clock and also 16mm to the edge of the rounded bottom corner.
Then I melted the nuts into the holes, and screwed the stand to the clock.
Finally I used 4 rubber feet (diameter ~8mm) and glued them at the bottom of the stand.
Also I use an USB-C cable with an 90deg. angled connector.