Ableton Push 2 USB-C 适配器

Ableton Push 2 USB-C Adapter

2024-03-26 22:34:00

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is an adapter for the Ableton Push 2 in order to use it with the nowadays standard USB-C connector. The adapter consist of one DC jack and USB-B male connectors in order to connect to the Push 2, and two USB-C female connectors, one for data, to be connected to the computer, and one for power, to be connected to a Power Delivery compliant power supply or wall adapter.

This is only the adapter case, to complete the project you'll need:

USB-B male connector
DC jack male connector - 5.5mm outer diameter x 2.5mm inner diameter
USB-C breakout board
USB-C PD decoy board at 12V (rated for at least 1.25A)
Wires and basic soldering skills

All of these components can be easly found on Aliexpress for cheap. As for the PD decoy board I used a cheap one based on the LP2721 integrated circuit, that can be found by searching for PDC004-PD boards. Remember to use a 12V one, that's important.

In order to fit the connectors inside the case I had to trim excess metal at the end of the connectors. I fixed the connectors and boards in place with plenty of epoxy glue and soldered the connectors to the relative boards. I suggest using thick wires for the DC jack.

In the attached images you can see the pinout of a standard USB-B male connector but remember to always double check! You just need to solder the signals to the relative one present of the USB-C breakout board. Keep in mind that this image shows the connector from the front, while you solder wires in the back.

Be extremely carefull when wiring all together, inverting the polarity of the voltage can damage your device, but if you know what you're doing this is a very cheap and easy project to complete.

Happy printing!

IMPORTANT: The inclusion of Ableton logo on the lid is purely for aestetic, this is not a licensed nor official Ableton product. Also, an incorrect wiring or the wrong selection of the PD decoy board output voltage may permanently damage your device. I abstain from any responsibility due to misuse.