淋浴头支架

Shower head holder

2023-03-26 19:02:20

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

I needed a holder for my shower head in the bathroom. First attempt was a simple version (also uploaded) based on my soap dish and basket. Although this worked fine for several months, I always had the impression that it might fall off eventually, because the shower head forms quite a lever and pulls on the simple rod clamp.

Therefore I decided to design a sturdy version, where the rod clamp can be secured with a screw. The shower clamp is tilted 45° with this version and the shower clamp is 3cm high and has a diameter of 23mm on the upper side and 21mm on the lower end to firmly hold the shower head. If you need a different angle, leave a comment, I might upload a remix if requested.

Unfortunately I couldn't come up with a design that doesn't require any support (as I did for the simple version), but to reduce the amount of required support I cut the double-clamp in two parts which must be glued together (guide pins should help proper positioning). If you prefer to avoid gluing, the double clamp is also uploaded as a single piece (but requires more support)

As the thin TPU layer provides excellent grip on the rod, I didn't design a remix that can be printed in PLA only. If you want to try one, leave a comment, then I might upload another version for pure PLA or PETG without TPU.

淋浴头支架

朋友，你觉得上面这个模型，属于下面的哪个分类？