CLSP 鞋修补机卷线装置

CLSP shoe patcher bobbin winder

2024-03-27 11:20:07

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Press in (2) skateboard bearings (608RS) on each sides of the tower with a vise. The shaft is a 3" M5 bolt with the head cut off. You'll have to slightly taper the point so the bobbin jams in place. Buy two... and use the first to practice with the taper. ;) I did this with the shaft chucked in a drill on a grindstone.

The magnet is a 32mm neodymium magnet with a hole in the center. Put nuts/washers on both sides of the tower. Install a third nut/washer on the backside of the magnet. Glue all these in place with red Threadlocker (Including the magnet to the washer/nut.

The bushing fits over the shaft and contacts the inner bearing runs.

It works great.