双树SK1摄像机支架

Two Trees SK1 Camera Mount

2024-03-28 08:35:01

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a 2 or 3 part print, based on your camera mounting needs.
This uses the Two Trees holes in the case for mounting the camera.

Minimum hardware needed, 3 M3x8 bolts, hinge point is designed for caphead.

if your camera mounts with a 1/4-20 bolt, you will need one at 1/2" long to fit properly, and not be too long or too short.

If you have heatserts, the M3x6 will fit into all 3 holes in the heatsert camera base.

The nosert prints are for those who have M3 hardware, and holds sufficiently on first attachement, but I make no promises for hole reuse if it needs to be removed repeatedly.

The elp is for the camera series with 40mmx40mm sides backer boards, and requires 4 M2x8 bolts, and if using heatserts any up to 4mm in length will work.

the 0.25-20 is the 1/4-20 mount for cameras with a 1/4"-20 thread hole to mount them by, like the Logitech C615 which also may need the spacer washer to get the mount to be flat to the base.

The mounting finger was designed to be pointed upwards or downwards, to allow for more control over the lens location.

These when printed on the Two Trees, in PLA or PETG, you should aim for roughly 20% infill, and its designed to print correctly with no supports.

All objects are designed to load and print without any rotation needed.

Print Settings

Printer:
Two Trees SK1
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2
Infill:
20
Filament brand:
generic
Filament color:
printers choice
Filament material:
PLA or PETG
Notes:
All angles are designed to not require supports when printed on a Two Trees SK1, which is kind of expected since this is the camera mount for the TT SK1 printer.