亚欧 VX-8DR 箱体模型

Yaesu VX-8DR Case

2024-03-30 00:35:25

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I have a created a model of a tectical style case for a Ham Radio HT the Yaesu VX-8DR. It is modeled to fit the radio with the OEM standard size battery, with the battery clip on it. But obviously will fit and retain the radio if you take the battery clip off.

My intent is to wear the radio on my belt and the model has two holes that line up with Safariland Equipment Locking System. But very likely the holes probably line up with a TEK LOK and other products. Links to this stuff is at the buttom.

The radio fits snuggly and is retained by friction between the case and the rubber overmold on the HT. I used Overture PLA to print out my units. I can shake the case with the radio in it and it not fall out. If you are running or doing extreme activities I would run some shock cord through your belt or something to retain, but again my radio is staying in place. Your mileage will vary.

There is a cut out in the back so you can keep the belt clip on and inplace.
There is a cut out on the right side so you can use a plugged in ear buds.
There is a cut out on the left side so you can access the buttons.
There is a cut out in front of the speaker to with audio transmission.
There is a drain port on the bottom too.

I may post an update at some point with an additional version with a hole to afix shock cord to the case. But if I do it'll be later on. Any additional ideas/features you would like or I missed let me know.

Safariland ELS - https://safariland.com/products/equipment-locking-system-kit-32184/
Amazon has this stuff too.

I use black Malice Clips as the belt loop.
https://www.amazon.com/Tactical-Tailor-Malice-Clips-Coyote/dp/B011AC7ACW/

Print Settings

Printer brand:
Anycubic
Printer:
Kobra Max
Rafts:
Yes
Supports:
No
Resolution:
.2 - .4
Infill:
60
Filament brand:
Overture
Filament color:
Orange but any color will work
Filament material:
PLA
Notes:
When I print my final Alpha unit. I did 60% infill in the Gyroid pattern cause I wanted it to be as rugged as it could be. That is not needed, 30% with triangles or grid would probably be fine.