Bambu X1 校准工具

Bambu X1 Calibration and Prime Strip Remover/Scraper

2024-03-30 07:57:10

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I hate having to remove the build plate from the chamber just to scrape the calibration and prime strips from it, so I came up with this oddball little scraper that's just big enough for those two strips, also keeps finger prints off of your build plate and can save your fingernail beds.

Lay it down flat against the plate at the beginning of the triangle part of the calibration strip, and slide it backwards, the strip will pop up in the slot. same with the purge/prime strip, just around a corner lol.

This is the first thing I tried designing in Plasticity as well, so it's only been tested a few times. ideas for improvement are welcome!

Print Settings

Printer brand:
Bambulabs
Printer:
Bambu X1C
Rafts:
No
Supports:
Doesn't Matter
Resolution:
0.2
Infill:
Any
Notes:
I printed it standing on it's nose, but some have had better luck with flat down and supports to get a sharper edge. to remove the front strip it doesn't need to be sharp, but might be easier to remove the back strip.