IFD-175 EX Bambu Lab X1c/P1s 支架

IFD-175 EX Mount for Bambu Lab X1c/P1s With magnet cutout

2024-04-01 10:27:35

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I modified the Thordsen IFD-175 EX Mount Assembly to use a 60x10x5mm Neodymium Bar Magnet instead of just 2-sided tape. These are strong magnets and the mount will stay in place.

These are the magnets I used: https://a.co/d/bisCo06

You can use any magnets that are the same size, look at image for dimentions.

I used Gorilla Super Glue to hold magnet in place.

Print flat on the bed as oriented in the STL file.
Make sure your support settings are dialed in, so that supports comeout clean. This is needed so that the magnet can fit in all the way and be flush with the part exterior.

I printed on PA6-CF Nylon, but this part will work with most filaments.

.16mm Layer Height, 100% infill, Use supports.if your prints tent to warp, use glue on the bed.

I applyed the glue to the cut out, making sure all surfaces got covered, then i let dry for 1-2 minutes before using a small rubber mallet to tap the magnet in. Its a tight fit.

If this worked out for you, post a photo of your set up so that it helps other deside if this might be of help for them.