一次性手套自动发射装置

Disposable Glove Dispenser

2024-04-02 22:12:57

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

A basic wall mounted disposable glove dispenser. Should hold most 100 & 150 count disposable glove boxes. Mounts to the wall with three screws and there is a drill template PDF for locating the holes. Be sure to print the template at 100% scale and check the dimensions before drilling. Not all printers print accurately and you may need to tweak the scale to get the dimensions correct. The inside dimension are 81.7mm x 135.7mm.

You can also mount it using double sided tape, Velcro, 3M command strips, etc... For these methods you should print the ‘no holes’ version which has a flat back. The mounting hole standoffs on the normal version may hold the back too far off the wall for tape to contact if it is too thin. The ‘no holes’ version has a flat back so even thin tapes can be used.
It prints with no supports in it's normal position however there is a small chamfer on the bottom surface to maintain the finished look. I recommend glue on the bed as this type of chamfer on the bottom surface can encourage warping at the corners. Kind of a pain but sometime I prefer form over ease of printing. I printed two in PLA with the a default .2mm profile on my X1 carbon they and they printed great.

A shout out to Ekaterina Sokolova for the glove icon I used on the front.