便携式旋转钥匙扣挂架(重新设计版)
Portable Spinning Keychain Hanger (Redesigned)
使用说明
- 所有模型资源均由用户上传分享,内容来源于网络公开资源
- 侵权投诉:通过抖音私信 @jobsfan 联系我们(需附版权证明),24小时内处理
- 模型将通过邮件发送(5分钟内自动发货),感谢理解带宽压力
关于费用
我们是爱好者共建社区,为维持服务器成本,每个模型收取微量费用(仅覆盖基础开支)。我们承诺最低成本运营,感谢您的支持!
扫码手机访问
抖音私信 @jobsfanSummary
A redesign of my original Portable Spinning Keychain Hanger, located here:
https://cults3d.com/en/3d-model/jewelry/keychain-display-rotating-hanger
which originally had the entire pole or center cylinders spin together with the hanger arms.
This version allows each level to spin freely and also has a sturdier base, which was redesigned to allow the user to fill it up with sand (once filled, superglue the cap to the base as it was designed to be permanently sealed). This keeps the hanger from toppling over.
The portability aspect was kept, however this time instead of each center cylinder unscrewing into the lower one, each cylinder is instead unscrewed one after the other.
This is also a modular design, meaning if you want to add another level, you can print another one of the Second Cylinder P2 and another Bearing with Bearing Cover + Arms, although I do not recommend doing this without filling up the base with sand before.
The Arms Ends pieces are the parts that go in the holes on each of the Arms in order to keep the keychains from falling out.
The Top Cap part is the piece used as the last/top section of the hanger in order to "finish" it.
If you are using brims, I attached a picture of where you should make some cuts in order to free the rotating arms. Make sure to get rid of all the brims around this area as it will affect the rotation.
Print Settings
- Printer brand:
Artillery
- Printer:
Artillery Sidewinder X2
- Rafts:No
- Supports:Yes
- Resolution:0.2
- Infill:15%
- Filament brand:
eSUN
- Filament color:
Red
- Filament material:
PLA
- Notes:
Supports were only needed for the Arms Ends piece.
I recommend you reduce the cylinder printing speed to 20 mm/s, unless you have a CoreXY printer as a bed slinger going too fast might affect the surface finish and tolerances of the model.
Tags
相关内容
猜你喜欢
联系我们
最新模型
-
帕特农神庙2024-05-08
-
RAM 垂直式笔记本支架2024-05-08
-
简易蘑菇模型2024-05-08
-
Shift Collar Boot Support - 可调节领口靴子支撑2024-05-06
-
Arma Grom舵机/ESC安装架2024-05-06
最热下载
-
3D模型:Easier Print LTT螺丝刀拉拔器2024-01-14
-
Kumonga的孩子与澳大利亚蜘蛛驯兽队2024-03-17
-
7英寸HDMI显示器-B外壳2024-04-01
-
罗宾:不公正22024-04-07
-
BlueSCSI v2 SPARCstation驱动器支架及密封环2024-04-14