Adder - Inscryption卡牌 - Hueforge

Adder - Inscryption Cards - Hueforge

2024-04-05 07:00:15

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

And now to start going down the list in alphabetical order. Starting with the Adder. It always felt like an expensive card.

The Pelts and Holographic cards will be done closer to the end. Ill need to figure out good colors for them.

Feel free to share. The source of the original image can be found in the link below.

https://cards.vladde.me/

Ive been pretty busy making these. However, I dont like uploading files until ive printed it successfully at least once.

This time around im not including the 3mf file and instead you will need to follow the directions of the "_describe.txt" file for instructions on what layers to swap the colors at.

You will need to reduce the size of the model. I would suggest reducing the X and Y by 50%, but make sure to leave Z at 100%. If you modify the Z attribute the instructions will not be valid.

Printing Tips - I would highly suggest reducing the print bed temps from your usual settings when printing with PLA. High temp beds tend to make the corners curl. I would also suggest using a print adhesion product of some kind to help it stick. These are 4 hour prints, and it sucks to have it ruined by a bad corner.