框架13号人像支撑台 '反叛者'

Framework 13 portrait stand "The Rebel"

2024-04-06 22:36:35

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I had so much fun designing my vertical laptop stand for the Framework 13 that I had to make another one. Admittedly, this one is much less useful.

I call it "The Rebel" because it rebels against sensible laptop stand design^^

Advantages over my other design:

The stand is a single piece
Your screen is in portrait mode?!

Disadvantages:

The stand isn't flat. That makes it less convenient to carry around.
The stand is less stable. Lightly pushing the laptop in any direction is no problem, but anything more can topple this thing. Pulling on a cable, bumping into it with an elbow or similar could cause some damage.
One of the four ports is completely blocked. Another one is difficult to access, depending on how big the plug of the cable is. Luckily, you can swap the ports around on the Framework to mitigate this issue.
Your screen is in portrait mode?!

Note that the fit is a little tight along the edge of the screen. Lightly pushing the laptop in will do the trick, because the plastic of the bezel is somewhat flexible. I like it this way, makes it feel more stable. But you could loosen the fit by adjusting a single parameter in the source code.

I'm kinda proud of the nicely rounded edges along the top. On the other hand, the OpenSCAD code takes a while to compile because of that.

The source is here. (public domain, Unlicense)