A 小型齿轮盒

A Tiny Whoop "Gear" Box

2024-04-08 09:16:44

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

A Tiny Whoop "Gear" box for storage of:
x1 - 65mm Tiny whoop
x4 - 300mAh 1S cells

The battery tray is removable from the gear box - which I found to be more convenient. The top and bottom lids can either snap fit together or thread together. The press-fit version is the intended option. The threaded version has only worked OK-ish for me as it's very easy to cross thread if you aren't careful about alignment before screwing the top and bottom together - So I'd only go with the threaded option if you are curious and / or OK with careful tightening of the lid.

The Tiny Whoop logo is slightly offset from the base surface for ease of multi-color print surface selection, but will print just fine without supports. Also I was unsatisfied with the quality of the Tiny Whoop logos available here or elsewhere, so I recreated the logo by hand while referencing an overlaid .png of the Tiny Whoop logo. Turned out pretty good I think!

NOTE: I created this storage "gear" box from scratch, but it was inspired by a very similar design for a Go Pro camera box by HD_Design on Maker's World. I liked how it looked and thought it would make a nice storage solution for a Tiny Whoop. So here we are ;-)