Tune To sign (SEED)

2024-04-13 21:22:21

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a "Tune to" sign for seeds. These "seeds" are the new design from visionarylightshows.com. (4/13/2024) They are the thicker wire. I have NOT tried this out on any other seeds.

To use: Just lay the seed in the cut out, and place a clip on either side of the "Seed" there are divots that the bracket will clip into. There are holes between the "seeds" for the wire to be pushed into for a clean look.

Each panel is 175mm x 116mm ( approx 6.88 inches x 4.56 inches) and holds 25 "seeds"

Each panel is bolted together using #6-32 x 3/8 bolt and nut i picked up at Lowes.

The BRACKET should be printed at a layer height 0.12 and 3 walls work good for me
with PETG. This was printed on a BAMBU P1P Tolerances may differ from machine to machine.

The PANEL was printed at a layer height 0.2 and 3 walls.