Teenage Engineering EP–133 K.O. II 防护罩

Teenage Engineering EP–133 K.O. II Protective Cover

2024-04-14 09:48:49

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I wanted a cover/crush protector for the EP-133 so I can throw it in a bag for travel. I grabbed the official bag from TE, but it's a soft bag, so I made a cover to go along with that bag.

The initial concept was a basic printed shell, but realized if I wanted to keep the profile as low as possible, the center of the shell could flex enough to contact the fader and pots, so I added pillars that register around the knobs and fader. It also occurred to me that 3D printed plastic rubbing against the surface of the device could scratch it up.

My solution was to use my XL to mix PLA with TPU for the parts that actually make contact. It's just friction fit for now, but it works for my needs.

There is an XL 3MF that I used to print my case. I figured since I was doing multi material, I might as well add some TE style graphics. There is also a 3MF for the MK4. The case should fit fine on a MK3/MK4 or X1/P1P/P1S build plate. No supports needed.

I would recommend that if you print in only one hard material, you use as a deck saver only, as I cannot guarantee that it will not scratch up the surface of your EP-133.

In the pictures is Prusament Galaxy Black and Galaxy Silver PLA, and the red is Overture TPU.