3dsjs

闪电立智能手机(测试版)

BoltStand SmatPhone (beta)

2024-04-14 20:21:07

使用说明

  1. 所有模型资源均由用户上传分享,内容来源于网络公开资源
  2. 侵权投诉:通过抖音私信 @jobsfan 联系我们(需附版权证明),24小时内处理
  3. 模型将通过邮件发送(5分钟内自动发送),感谢理解带宽压力,超过1小时没收到,请联系我们
关于费用

我们是爱好者共建社区,为维持服务器成本,每个模型收取微量费用(仅覆盖基础开支)。我们承诺最低成本运营,感谢您的支持!

扫码手机访问
抖音私信 @jobsfan

Summary

Having a support for the SmartPhone is usually useful, the objective was to be able to vary its inclination using simple elements, after giving the idea many thoughts, I opted for an M6x80 screw with a 1 mm pitch in the thread, one of the most common on the market, as part of the mechanism. The route after tests in the drawing program would be enough to vary the inclination between 30° and 85° (plus degree, minus degree)

The concept is simple (I think), a sliding piece that houses a nut changes the inclination, turning the screw transports the piece that raises the inclination of the bed of the device.
The pieces did not require much rectification, printed at 0.20 (layer height), a file review of the screw hole so that it rotates freely, perhaps a little sanding of the piece that houses the nut in its base to give a good clearance to the assembly if you feel it forced when assembling it and not much else. The piece that acts as a wheel to rotate the mechanism is threaded under pressure on the screw, which is why it has a hexagonal through hole, so as not to leave our fingers straining with the screw. Once assembled, the mechanism almost has a resolution of minutes of arc in inclination (exaggerated I know)
The stability to the left and right is solved with an extra piece that I include in the kit, a hexagonal cut piece, but if you have a pencil with a hexagonal body forgotten by the desk, you already have the piece that completes the stability of the set. .
The support is designed to support a phone with its case, which is why the receptacle is so wide and the central space is for the charging cable.

I plan to modify the SmartPhone supports to fix it on the sides when it is vertical on it, a change that I will attach shortly.
And finally, you will notice that the base in its front section has a dove shape of about 4 cm, the idea is that the support can be attached to another element (which I am finishing developing)

Impression:
• Layer height: 0.20 (optimal result)
• Supports: NO

Tags

License

CC BY-NC-SA

BoltStand SmatPhone (beta)
by DarthMupet is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.

闪电立智能手机(测试版)
朋友,你觉得上面这个模型,属于下面的哪个分类?
必须全中文,且长度不超过15

相关内容

猜你喜欢