Casting Aid / Breakaway Cannon

2024-04-15 12:34:47

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Other than needing to set it (which can be learnt here youtube.com/watch?v=1JPg9yatgpQ), this casting aid works just like regular casting but without the risk of cuts.

Print Settings

Printer brand:
Creality
Printer:
Ender 5
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.12mm
Infill:
30%
Filament brand:
-
Filament color:
Black
Filament material:
PLA
Notes:
The print should be done with supports on overhangs larger than 60* (i used CURA's defaults for this).
The body (body.stl) should be printed with the flat side down and the arm (arm.stl) horizontal with the trigger up on the print surface.
Note: This object is not ideal for 3d printing because of its shape and to make it as strong as possible, but should be do-able.

Make sure to print with as many walls as possible (I used 3), 2 or fewer might break with ease on very large weights and rods.

Post-Printing

Fitting

This print is designed to fit any rod size by softening the PLA with hot water. I find pouring hot water from a kettle on the flat side of the body while holding it with some pliers works. Then quickly I used a glue stick to mold the plastic on.

I then attached the arm/trigger with a piece of wire (preferably stainless steel) and bent
either side so it wouldn't fall off but could still pivot, you can see where the wire feeds though in the holes of each model.

Finally, just zip tie (minimum one) to the rod and enjoy.