1英寸内径ENT低压导管连接器适配器

Connector for 1 inch ID ENT Low Voltage Conduit Adapter

2024-04-16 09:47:47

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I wanted to run some conduit between and through studs before drywalling during basement finishing, and this fitting was used to connect the conduit to the low voltage brackets. There is another similar adapter on the site, but it didnt fit the 1" conduit I was using.

The threads on this part work with standard 1" Conduit Locknuts (Halex Part #96193 from Home Depot). However, the threads are designed straight and not angled like traditional NPT threads. If I have time later, I will design a 3d printed nut to fit them as well.

This fitting is made to replace Carlon Model# A243F-CAR from Home Depot.
I used it to connect the Carlon low voltage new construction bracket (Model# SC100A) from Home Depot, to the Cantex 1"ID ENT conduit (Model # LA51BAD1) from Lowes.

This print is designed to print without supports, and easily prints well in large batches. Pushing the conduit into the adapter will lock it in place. Squeezing the adapter on the sides WITHOUT the tabs allows the conduit to easily pull back out if needed for further trimming.