Blade 130 S 天篷盖混改版适用于花瓶模式打印

Blade 130 S Canopy remix for vase mode printing

2024-04-17 03:15:26

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

The original model is very difficult to print. Due to the support, it is slow and uses a lot of material.
I just added it so that it is possible to print in vase (spiralize) mode. This way, you can print much faster, prettier, more economical and simpler, with a single wall thickness. The thickness of the wall can be adjusted by adjusting the diameter of the nozzle, but the 0.4 mm nozzle was suitable for me.

I printed from PLA, it is fragile. You can't cut it around with scissors, because it will crack, so I cut it out with a 180°C, thin-tipped soldering iron.

Unfortunately, the original model does not fit the Blade130S perfectly. The upper opening will have to be expanded a little to accommodate the control rods.
It will probably get damaged soon, but it's still better than buying an original for $15 when it can be printed from 10 grams of PLA in a couple of hours.

Layer resolution 0.2mm
Nozzle: 0.4mm
Material: PLA

Cura 3.6: Special Modes > Spiralize outer contours ON
Slic3r: Settings > Print settings > Layers and Perimeters > Spiral vase ON