热收缩密封件用于SOTABeams陷阱

Heatshrink glands for SOTABeams traps

2024-04-20 01:45:43

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I designed these 3D printable glands in OpenSCAD to allow SOTABeams traps to be easily waterproofed using standard glue-lined heatshrink. SOTABeams recommend liquid electrical tape, but I find this a bit messy and using heat shrink tubing provides a neater finish as well as giving additional protection.

I recommend threading the antenna wire through the gland and the 2 smaller strain-relief holes on the PCB. The hole in the side of the gland can then be used to fill the internal space with adhesive to prevent water ingress and secure the grommet to the PCB. The trap can then be sealed into 39mm diamater (3:1 shrink) glue lined heatshrink, which will seal nicely over the glands.

The attached STL has ~2mm diameter holes for the antenna cable. The .scad file is available in the github repo.

Would love to hear if anyone else makes use of these.