6毫米冷凝器线圈成型件

6mm condenser coil formers

2024-04-22 22:39:07

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a pretty niche design. Various formers designed to help shape a 6mm OD (0.6mm wall) copper tube into tight coils. The idea is that cold water is fed into the central tube, at the base of this tube the water is forced through both coils. With 2 coils in parallel the pressure should be lower, though it is likely that the flow rate will vary between coils.

The designs mostly allow 6.5mm diameter to allow for some flattening and so that the pipe can be freed from the formers after bending. The inner coil has a centre radius of 21.8mm, the outer 39.6 centreline radius.
In theory, with a 10mm diameter central pipe there should be a 2.9mm gap between central pipe & inner coil, between inner and outer coils and between outer coil and a 54mm pipe (1.2mm wall, 47.6ID).
The pipe bender does flatten the pipe considerably - even if copper is annealed, but is seems to be a functional 9.3mm centreline bend. I happened to have some 1.85mm filament and filament guide that fitted inside the pipe before bending. After bending first remove the 1.85 filament, then the filament guide tube should slide out.

Print Settings

Printer brand:
UltiMaker
Printer:
Ultimaker 2+
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
30
Filament brand:
RS
Filament material:
PLA
Notes:
Despite overhangs these models mostly printed fine in PLA without supports - the exception being the Pipe Bender which was printed flat and with supports where the overhang > 80°.