玩具宝箱

Toy Treasure Chest

2024-04-23 03:37:38

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a toy treasure chest which kids love or could be a nifty little storage container.

In the photos, I included a matchbox to try and give some perspective, but I don't think it was very clear. The base of the box is 120mm x 80mm x 80mm high and the domed lid adds about 30mm onto the height.

What is not in the photos but is in the STLs is a 4mm x 10mm deep hole in the lip of the base which aligns with a hole in the lip of the lid. This allows you to glue in a 4mm diameter rare earth magnet in either side, which is a pretty nifty latch solution that can't get broken easily.

The holes in the hinges are 3.1mm diameter, so that a 3mm round bar or piece of wire can work well as the hinge mechanism. In the photos you'll see I used 50mm wire nails that worked fine, they just need to be trimmed and then a spot of glue added so they don't work their way out.

My 8-year-old son asked for this, and when it came out so well the other two demanded their own. Its a really easy print and you can use your personal favourite materials and settings.

Print Settings

Printer brand:
Creality
Printer:
Ender 3 Pro
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2mm
Infill:
10%
Filament brand:
Sunlu
Filament color:
Red
Filament material:
PLA/PLA+
Notes:
I printed the PLA at 210 degrees and 65 degrees on the bed. I did the same with PLA+ and the job came out just as good. You may need to figure out the settings for your personal choice in brand/material.