3dsjs

Wolkenkraft FX Mini (Ultra) Blubber Enhancement 沃尔肯克劳夫特FX迷你(超极)增肥效果

Wolkenkraft FX Mini (Ultra) Blubber Enhancement

2024-04-24 19:07:28

使用说明

  1. 所有模型资源均由用户上传分享,内容来源于网络公开资源
  2. 侵权投诉:通过抖音私信 @jobsfan 联系我们(需附版权证明),24小时内处理
  3. 模型将通过邮件发送(5分钟内自动发送),感谢理解带宽压力,超过1小时没收到,请联系我们
关于费用

我们是爱好者共建社区,为维持服务器成本,每个模型收取微量费用(仅覆盖基础开支)。我们承诺最低成本运营,感谢您的支持!

扫码手机访问
抖音私信 @jobsfan

Summary

Wolkenkraft FX Mini (Ultra) Blubber Enhancement

This is a extension for the Blubber waterfilter for Wolkenkraft FX Mini (Ultra) vaporizers.

Source files included, feel free to rmx.

By extending the distance between the upper opening of the water-filter and your mouth, it should prevent you from sucking in splashes of extremely good tasting water.


How it works

While sucking on the water filter, there is a good chance that drops of water will reach the opening in the lid and being sucked up.
Then the drops will hit the inside of the walls of this extension and finally drain off, back into the reservoir.


Print Settings

  • Rafts:
    No
  • Supports:
    No
  • Resolution:
    0.15mm @ 0.8mmØ Nozzle
  • Infill:
    0%
  • Filament brand:

    esun

  • Filament color:

    Color Change by Temp

  • Filament material:

    TPU-A95

  • Notes:

    Print it with a brim to get good bed adhesion.

    This is intended to be printed with TPU-A95 in VASE MODE with a 0.8mmØ Nozzle
    The vase mode makes sure there is no seam where water could leak.

    If you are trying to print it with a smaller nozzle-diameter you should adjust some constraints in the source FreeCad file.
    It may lack stability if your TPU is softer than A95 or the nozzle-diameter you using is to small.
    Some testing revealed that printing it with a 0.8Nozzle works best.

    BTW, there is a unfinished version of a 2 Part enhancement in the source FreeCad file.
    Feel free to finish it and post it as a remix, if it works better for you.

Post-Printing

Cutting of the top

Since it's printed in vase mode, supports aren't possible.
This will lead to overhangs getting really ugly at some point.
This is where you should stop the print.
Take a sharp knife or scissors and cut off the ugly part.

Tags

License

CC BY-NC-SA

Wolkenkraft FX Mini (Ultra) Blubber Enhancement
by HtXF is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.

Wolkenkraft FX Mini (Ultra) Blubber Enhancement 沃尔肯克劳夫特FX迷你(超极)增肥效果
朋友,你觉得上面这个模型,属于下面的哪个分类?
必须全中文,且长度不超过15

猜你喜欢