Vive Pro头带角度调整模块

Vive Pro Headstrap Angle Mod

2024-04-28 15:57:05

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

TLDR

The Dremel guides helps you cut away a portion of the stops to allow the headset to tilt downward allowing even pressure on your face.
The hinge stiffeners allows more resistance on the strap. It allows you to crank down on the screw; further clamping the strap tighter and allowing resistance on the hinge (similar to the quest 2's hinge). This helps to keep the HMD at the desired angle.

Why??

Users of the VP noticed that the it puts too much pressure on the forehead and wouldn't tilt down enough to put even pressure on the user's face. There is already a mod that moves the hinge out further to bypass the angle stops however, I wanted a clean and sturdy setup. I opted to cut away a bit of the hinge stops resulting in a cleaner and more sturdy mount.

Details

You don't need to worry about the headphone cable stretching or pulling out, I haven't found that it pulls on it excessively or pinches it.
The threaded screw inserts on the head strap seem to be pretty beefy and they don't show any signs of pulling out after using this mod for a while.

It might work on the VP2, they seem to be almost exactly the same head strap and construction.

Voids the warranty (obviously).

Instructions

Dremel Guides:

Print out the Left and Right Dremel guides.
Tape off any cracks and vents painters tape.
Align the guides appropriately (as shown in the photos). With the inner edge aligned properly; it should cover over the part that you want to keep and the rest would be where you want to remove the plastic.
Tape down the guides to hold them in place and carefully cut out the plastic.
(Take your time!)