ZOHD Altus 大疆 O3 前部

ZOHD Altus DJI O3 nose

2024-04-29 02:48:42

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

My first take on redrawing a design from Burkeomatic from RC Groups.

Basically the nose has cutout for the O3 camera with 4 small holes to tighten the camera with M2 screws. Holes are a bit loose so there is a small amount of adjustment range for both moving the camera forward/back as well as tilting it slightly higher or lower.

My O3 is on a tray with standoffs so the unit is directly behind the top air inlet - 30min flights and no overheating.

I used a little longer UFL antennas and rotated the O3 VTX so that I can get access to the SD Card or USB port without the need to remove the nose.

Nose is mounted to the stock nose with two M2.5 screws, not sure if the stock ones are long enough. The bottom of the nose has a small thin edge that allows for flush positioning of it to the fuselage.

The three holes on the top are for either two separate antennas like I did or center one if someone goes with the stock O3 antenna.

I printed mine in regular PLA with stock 200/50 temperature settings and speed set to 60. Supports needed but they're not a lot of them.