电影盒型120号

Film case type 120

2024-05-03 00:51:44

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This product will help you keep the film from being illuminated before charging into the camera and, more importantly, after removing it from it. The gap in the thread is 0.2 mm per radius, 6 inlet thread with a pitch of 4 mm. The angle of the thread profile is 45 degrees, which allows printing without the use of supports. Immediately after printing, the thread may seem tight, it needs to be twisted several times until it runs out. I also included a version with a 0.25 mm gap if you think 0.2 mm is too small. But still, I recommend the version with a 0.2 mm gap.

Print Settings

Printer brand:
Flying Bear
Printer:
Ghost 6
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2
Infill:
100
Notes:
Z Seam Alignment=random

Post-Printing

It will take several times to assemble and disassemble before the resistance is eliminated. With increasing effort, disassemble and assemble into the next round of the multi-pass thread.