相对而言很小的小矮人齐柏林飞艇

Tiny (relatively speaking) Dwarf Zeppelin

2024-05-05 03:58:31

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

A small (not really) zeppelin to give some air superiority to your dwarfs!

The story is short: I wanted a zeppelin for my new Warmaster dwarf army and I didn't find anything I really liked, so I took the best pieces of everything I found and built my own zeppelin.

Since there are no official rules to use it in the game, I took the liberty of playing around with some ideas and in the end I decided that this zeppelin would be equipped with a conventional cannon and four "machine guns" (my idea is that they work in a similar way to imperial volleygun).

I plan to upload the rules to use it in the game, but I need to do some playtesting before sharing anything.

Now, a few notes regarding the impression that I should mention:

First, the balloon: I printed it in PLA only because my resin printer (a Halot One) is very small and I also felt that it was going to be too much for it, but if you have a printer with more testosterone than mine, I think you can try printing both parts in resin (don't forget to hollow them out).

Second, the gondola: I printed this in resin, but for the same reason as before, I did it in separate pieces. The problem I had was that I experienced some warping (I don't have much experience printing large, flat pieces), as a result ugly gaps were created between the pieces which I was forced to fill with epoxy putty and covered with a decorative trim that i sculpted by hand (which, for obvious reasons, is not included in the 3d model). I think the ideal is to print the entire gondola at once, although I cannot guarantee that it will turn out well, that depends on how you configure the model in the slicer, the supports and your printer.

Additionally, the anchors are fragile and may break or not print correctly, as happened to me. That's why I included a small anchor model in case you need to repair this piece.

Third, the base: If you are going to print it in PLA, I strongly recommend that you print the rod horizontally, that way you will give it much more resistance than if you print it vertically. I designed it to be inserted into the base from below. On the other hand, if you want to print the base and the rod in resin, I can't do anything other than wish you good luck xD