任天堂Switch游戏卡RCM夹具

Nintendo Switch Game Card RCM Jig

2024-05-05 11:21:04

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is an RCM jig for a Nintendo Switch which includes a holder that fits in the Game Card slot.

This is technically a remix ofan off-site design by Joe_84156 on Printableswhich isCC BY-NC-SAand allows remixes like this. I re-made the jig inOnShapeto use a different method of installing the wires that I have found to be much more reliable.

I am out of filament, so I can't test this currently. However, I will update this page with pictures and better instructions once I do.

Post-Printing

Step 1: Install the Wire

Install some long, thin wire into the holes with a loop tucked into the notch on the jig-s back end, just like all the other 3D-printed jigs have you do. Make sure it's long enough to hang over the edge.

Step 2: Cut the Wire

Trim the wires so 2-3 mm is left hanging off the connector edge.

Step 3: Bend and Flatten the Wires

Bend the wires all the way over the edge of the connector, and push the ends flush with the back of the connector. Make sure the wires are straight and flat, and you're done!